4. Place the chain (19) around the drive sprocket (28) loosely with the chain
links in the direction shown on the guide bar (18) (Fig F).
5. Insert the guide bar (18) into position over the 2 threaded studs, and on
a slight angle upwards, and push the guide bar (18) towards the drive
sprocket (28) to easily place the chain (19) around the guide bar (18). (Fig G)
6. To fit the chain (19), start by placing the chain (19) around the nose
sprocket of the guide bar (18) ensuring the chain (19) is fully located on the
drive sprocket (28) wheel (Fig F), and also fully in the channel around the
nose of the bar (Fig H).
7. With one hand, extend OUTWARD the guide bar
(18) to remove all slack of the chain (19) and
thus ensuring the chain (19) does not jump
out of the narrow drive sprocket (28) on the
chainsaw. With outward tension on the bar,
fit the chain (19) into the channel of the bar
completely. Only remove the outward tension
on the bar when the chain (19) is completely
fitted around the
guide bar (18) (Fig I).
G.
I.
Assembly
H.
F.
To Next Page
Loading...
