4. A bar cover (30) is supplied with this chainsaw
and should be fitted over the chain (19) and
guide bar (18) whenever the chainsaw is not
being used. This includes immediately after
use, transportation and service where possible.
The chain teeth are extremely sharp and could
create a safety hazard if the bar cover (30) is not
fitted. Furthermore, the bar cover (30) provides
protection to the chain cutting edge when the
saw is not in use (Fig AN).
WARNING: The chain has sharp edges.
Use work gloves for safety.
Vents:
1 . Clean any dust away from the cooling vents as clogged vents can cause
overheating.
Servicing
• It is recommended once you rst use your product to get it serviced after
15 hours of use.
• From thereafter, service the product every 2 years.
Transportation and Storage
Always fit the chain and bar cover (30) when the chainsaw is not in use.
It is recommended to drain BOTH fuel and oil from the chainsaw on the
completion of use, prior to storage or transportation.
Always sit the chainsaw on a surface where the leakage of oil will not be
a problem. The chainsaw is fitted with an oil pump and there will be after
use an amount of oil in the oil channels inside the chainsaw, and also in the
chain and bar channel. This oil can spill on to the surface the chainsaw is
sitting as it drains from the above points.
AN.
Maintenance
To Next Page
Loading...
