20
Maintenance, service, and inspection
Refi lling the oil
Risk of injury!
Filling the oil cylinder with too much oil can cause the jack to
become overloaded, resulting in injury.
− Only fi ll the oil cylinder with the amount recommended in this
chapter.
NOTICE!
Risk of damage!
Using the wrong oil may damage the jack or cause it to
malfunction.
− Only use the type of oil as given in the chapter “Technical
data.”
1. Fully lower the jack, make sure
the release screw
7
turned fully
clockwise, and lift up the cover
plate
3
.
2. Carefully lift up and remove
the rubber seal
12
of the oil
cylinder
13
up with a fl at-head
screwdriver.
3. Fill the oil until the piston rod of
the cylinder is barely covered.
Make sure that no oil is spilled. If necessary, use a small funnel
to fi ll the oil.
4. Clean the rubber seal and insert it back into the oil cylinder,
making sure to press it fi rmly back into place.
5. Lower the cover plate.
12
13
To Next Page
Loading...