PRODUCT USE
The device should not be used on surfaces that were treated with
wax. The hot and moist steam might lead to damage. Never use
the device on unsealed wooden surfaces and never let the device
rest on the same spot of a wooden floor over a prolonged period
of time - the wood might discolor or even swell. Be especially
careful when you use the device on heat-sensitive floors or floors
that were treated with heat-sensitive materials. Before using the
device, ask a specialist whether the respective floor is suitable for
steam cleaning. If necessary, test the device in an obscure corner
of the surface to be treated.
We recommend sweeping and/or vacuuming the surface to be
treated before using the steam mop.
Before cleaning the floor, plan out where you will start and where
you will finish your work to avoid stepping on already cleaned,
potentially wet surfaces while cleaning.
• Put the prepared device close to a properly installed grounded power
outlet. Ensure easy access of the grounded power outlet.
• Pull the power cord completely out of the cable rewind (3) and plug the
device into the grounded power outlet.
• The heating process in the device‘s interior starts immediately, the mains
connection and the heating process are indicated by the burning operat-
ing control lamp (7). The heating process takes only a little while until the
device is operational.
• Press the steam button (2) to let steam escape from the cleaning head
(8). You can stop the steam by pressing the steam button (2) again.
Product use
NOTICE
NOTICE
NOTICE
You can also use the device for cleaning carpeting. For this, insert
the cleaning head (together with the attached fabric cover) into
the carpet glider attachment.
Attention: Do not rest the device on the same surface spot for too long,
particularly if the steam function is switched on. You might damage the floor
and/or have lime residue on the floor.
• Pull and push the cleaning head (8) carefully over the surface to be cleaned
and, if required, also into corners.
• Always keep monitoring the water level in the water tank (5). The device
must not be operated without water (in the tank).
The steam function of the device must be switched off after every use of
the steam button (2) by pressing it again, and then the device must be dis-
connected from the power supply by unplugging the power plug from the
grounded power outlet (do not pull the power cord). Let the device and all
accessory parts cool down to room temperature before attempting to remove
(or attach) any accessories and before cleaning and/or storing the device.
Caution: After use of the device, the fabric cover will be very
hot; you need to let it cool down to room temperature before
you can remove it from the cleaning head.
• Empty the water tank (5) after every use and remove the fabric cover (11).
• Rewind the power cord onto the cable rewind (3) and store the device
upright in a dry place.
NOTICE
CAUTION
21 22
MODEL: DM 2012 PRODUCT CODE: 40041 10/2015
MODEL: DM 2012 PRODUCT CODE: 40041 10/2015
AFTER SALES SUPPORT AFTER SALES SUPPORT
1-800-886-8506
USA
USA
USA
USA
Steam Mop
Steam Mop
1-800-886-8506
hup-service@h-u-p.com hup-service@h-u-p.com
Product use
To Next Page
Loading...
