20
Dehumidifi er
runs too
much but
does not col-
lect water
• Need to reset
controller
• Set to 40% RH. Allow
bucket to fi ll and then
empty bucket. Adjust con-
troller to desired % RH.
Dehumidifer
runs too
much col-
lects water
• Area to be
dehumidifed is
too large
• Doors and
windows are
open
• The capacity of your
dehumidifi er may not be
adequate
• Close all doors and
windows
Frost ap-
pears on the
coils
• Unit has been
recently turned
on, or room
temperature
is below 5°C
(41°F)
• This is normal. Frost will
usually disappear within
60 minutes. See the
“Defrost” section
Controls
cannot be
set
• The compres-
sor will turn off
and the fan will
automatically
continue to run
for approx. 3
minutes at a
fi xed setting
• This is normal. Wait
approximately 3 minutes
and set the fan as
desired.
Fan noise
• Air is moving
through the
dehumidifi er
• This is normal
Water on
fl oor
• Hose connec-
tion may be
loose
• Bucket used to
collect water,
but the hose is
attached
• Check the hose connec-
tion. See “Continuous
Drain” section
• Disconnect the hose if
using the bucket to collect
water, see “Continuous
Drain” section.
Consumer Service: 1-800-263-2629
Troubleshooting
Description of malfunction:
Return your completed
warranty card to:
Danby Products Ltd
5070 Whitelaw Rd
Guelph, Ontario
Canada
N1H 6Z9
consumerservice@danby.com
2
YEAR
WARRANTY
WARRANTY CARD
50 PINT DEHUMIDIFIER
AFTER SALES SUPPORT
MODEL: EDR050BAUW
52494
06/2017
consumerservice@danby.com
1-800-263-2629
Your Details
Name:
Address:
Date of Purchase:
*Keep the receipt with this warranty card
Location of Purchase:
Hotline: 1-800-263-2629
Call charges from your regular
landline operator.
Phone lines available:
Monday - Thursday
8:30 am - 6 pm EST
Friday - 8:30 am - 4 pm EST