ALDI FERREX BCH3200PB4 - Troubleshooting Common Issues

Kapitelüberschrift
34
13. Troubleshooting
Fault Possible Cause Remedy
The equipment
does
not start.
• Correct starting procedure not
followed.
• Sooted or damp spark plug.
• Incorrect carburetor setting.
• Blade or nylon cutter mounted
incorrectly.
• No fuel in the tank.
• Follow the instructions for starting
• Clean the spark plug or replace it
with a new one.
• Contact an authorized customer
service outlet.
• Reassemble the blade or nylon
cutter.
• Check the fuel level.
The equipment
starts
but does not
develop
its full power.
• Incorrect choke lever setting.
• Soiled air filter.
• Incorrect carburetor setting.
• Cutting blade blunt.
• Set the choke lever on the
position.
• Clean the air filter.
• Contact an authorized customer
service outlet.
• Have cutting blade resharpened /
replaced.
The engine
does not
run smoothly.
• Incorrect electrode gap on the
spark plug.
• Incorrect carburetor setting.
• Clean the spark plug and adjust the
electrode gap, or fit a new spark
plug.
• Contact an authorized customer
service outlet.
If the tempera-
ture of
machines is too
high.
• Engine is overloaded. • Insure the machines have rest at
regular time.
If the machine
will not turn off.
• Connection on/off switch
defective.
• Put the choke lever (14) on the
position. This will stall the engine.
Troubleshooting