ALDI FERREX CBV18F.9 - Operation; Starting & Stopping; Using the Blower

12
MODEL No.: CBV18F.9 • 10/2022 • 709610
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
20V Li-Ion Cordless Blower Skin
13
MODEL No.: CBV18F.9 • 10/2022 • 709610
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
(toll free)
20V Li-Ion Cordless Blower Skin
1800 909 909
1. Starting & stopping (See Fig. D)
- Starting
Move the on/o switch (1) to the "1", "2", "3", "4"
or "MAX“ to start the blower.
Speed "1" is the lower speed. Speed "MAX" is the
highest speed.
- Stopping
Move the on/o switch (1) to the “0” O position.
WARNING! The blower runs for a few seconds after it has been
switched o.
NOTE: Let the motor come to a complete standstill before setting the
blower down.
2. Using the blower
WARNING: During operation of the blower it is recommended to
wear eye protection, a dust mask, and full hearing protection.
Ensure you are wearing suitable clothing.
User tips
- Adjust the blowing speed according to the desired working condition.
- Hold the blow tube approximately 20 cm above the ground when
operating the blower.
- Use a sweeping motion from side to side. Advance slowly keeping the
accumulated debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to dispose of the
pile.
Caution!
- Do not blow hard objects such as nails, bolts, or rocks. It is
recommended to inspect the area you are blowing before starting use
Operation
D