3. Bleed the compressor and all connected pneumatic tools as described in the
chapter “Cleaning”.
4. Store the compressor in a dry, safe place.
Troubleshooting
WARNING!
Risk of electric shock!
If you open the compressor or repair it improperly, there is a risk
of electrical shock.
- Never open the housing of the compressor.
- Only have an authorised service outlet or customer service
repair the compressor.
- Immediately disconnect the compressor from the power
supply in the event of an error.
This compressor requires no maintenance. If a problem occurs, proceed as follows:
1. Disconnect the compressor from the power supply.
2. Let the compressor cool off.
3. Make sure that the compressor is in safe condition.
4. Use the following table to determine the cause of the problem.
Problem
Solution
The compressor doesn’t start.
■ Check whether the mains voltage, cord, fuse and
socket are functioning properly.
■ Do not use an extension cord that is too long.
■ Do not use the compressor at ambient temperatures
below 5 °C.
■ Avoid overheating the motor; let the compressor
cool off.
The working pressure is too low.
■ Check all gaskets and the non-return valve. If
necessary, have it replaced by a qualified specialist.
The tools are not working.
■ Check all hoses, the quick coupling and all tools and
have them replaced by a qualified specialist if
necessary
Storage
26
To Next Page
Loading...
Need help?
General
