10. Set the On/Off switch to the “0” position as soon as the desired or maximum
permissible working pressure has been reached.
11. If you no longer wish to use the compressor, pull the mains plug and follow the
steps described in the chapter “Switching the compressor on and off”.
Use as a blow-out gun
You can also use the pneumac gun as a blow-out gun to clean out cavies or hard-to-
reach areas.
1. Disconnect the pneumatic gun
15
from the compressor as shown in the chapter
“Disconnecting the pneumatic gun” (see Fig. A).
2. Screw the hose 18 off the pneumatic gun.
3. Screw the blow-out adapter 13 onto the pneumatic gun.
4. Connect the pneumatic gun to the compressor as described in the chapter
“Connecting the pneumatic gun”.
5. You can now switch the compressor on as described in the chapter “Switching
the compressor on and off”.
Cleaning
WARNING!
Danger of explosion!
The compressor or the attached tools may be in a pressurised
state.
- Bleed the compressor completely before performing any
cleaning and maintenance.
- Regularly maintain the compressor and have necessary
maintenance and repair work performed without delay.
WARNING!
Risk of electric shock!
Water that has penetrated the housing may cause a short circuit.
There is a risk of electric shock.
- Never immerse the compressor in water.
- Never use a high-pressure cleaner to clean the compressor.
- Make sure that no water penetrates the housing.
Operation
23
To Next Page
Loading...
Need help?
General
