Troubleshooting
15
Inserting and removing the battery
− To insert the battery, slide it into the guide rail located at the bottom of the handle
until you hear and feel it click into place (see Fig. B).
− To remove the battery, depress the battery release and pull out the battery (see
Fig.C).
Troubleshooting
Problem Possible causes Solution
The product does
not turn on.
The battery does not have
enough power.
Charge the battery.
The battery has not been in-
serted properly.
Slide the battery into the guide
rail on the product’s handle.
The battery must lock into place
with an audible and noticeable
click.
The direction switch
2
is in
the middle position.
Press the direction switch all the
way in the desired direction.
Cleaning and maintenance
WARNING!
Risk of injury!
Accidentally starting the product may result in severe injury.
− Remove the battery before performing any cleaning or maintenance work
on the product.
NOTICE!
Risk of damage!
Water or other liquids that have penetrated the housing may cause a short circuit.
− Never submerge the product in water or other liquids.
− Make sure that no water or any other liquids get into the housing.
To Next Page
Loading...