ALDI FERREX XG-KF2000 - Engine oil replacement

19
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. XG-KF2000 • 03/2020 • 700069
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
Digital Inverter Generator with Pure Sine Wave
MODEL: №. XG-KF2000 • 03/2020 • 700069
2. Remove the oil ller cap/dipstick (12) by rotating the cap in an anti-
clockwise direction, and wipe all oil residue o the oil ller cap/dipstick
(12) with a clean rag. Re insert the oil ller cap/dipstick (12) and thread
the cap fully in position.
Then remove the oil ller cap/dipstick (12) by rotating in an anti
clockwise direction and view the oil level on the oil ller cap/dipstick
(12).
3. If the oil level is close to or below the lower level line, rell using the
supplied oil bottle (32) with 4 stroke oil to the upper level line (Fig E).
Do not use the generator when the oil level is close to the low level. Fill
the oil tank before use each time.
4. If the oil is contaminated or has
discoloured, ensure you change the oil.
Replace the oil ller cap/dipstick (12). DO
NOT start the generator with the oil ller
cap/dipstick (12) not rmly replaced.
NOTE: This engine is tted with a low oil
indicator light (4). If the oil level is too low the
engine will stop operating or the engine will
not start. It is advised to check the oil level each
time the generator is used and ll to the upper mark on the oil ller cap/
dipstick (12) by the above method.
Do NOT over ll.
Engine oil replacement
There are 2 ways to drain the oil on this unit:
Method 1:
1. Place the generator on a at and level surface and warm up the engine
for several minutes. Then stop the engine.
2. Place an oil pan at the front of the generator ensuring it is in front of the
oil ller cap/dipstick (12) area. Commence removing the oil ller cap/
dipstick (12) by rotating in an anti clockwise direction to remove, so that
the oil can be completely drained from the oil reservoir.
WARNING: Oil may be warm to hot. It is recommended to wear gloves
for protection.
3. Screw the threaded end of the oil drain tube into the dipstick reservoir in
a clockwise direction until secured.
MAX MARK
LOWER MARK
E.