28
Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: info.aldi@positecgroup.com
1300 889 028
MODEL: №. XG-KF2000 • 03/2020 • 700069
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: info.aldi@positecgroup.com1300 889 028
Digital Inverter Generator with Pure Sine Wave
MODEL: №. XG-KF2000 • 03/2020 • 700069
Air Filter
It is very important to maintain an air lter (18) in proper condition. Damage to
the generator may arise if the lter has:
• Improperly been serviced.
• Dirt and other foreign elements adhering to the lter due to improper
installation and engine wear.
It is recommended the air lter (18) is cleaned every 50 hours (every 10 hours
under dusty conditions).
ALWAYS keep the lter clean at all times.
WARNING: Ensure the engine is switched o while undertaking this task.
1. Remove the air lter cover (17) on the side of the generator using the
supplied screwdriver (31) by removing (unscrewing) the 4 screws (1 on
each corner), in an anti-clockwise direction (Fig X).
2. Remove the air lter (18) by rst sliding out the tray (Fig Y).
3. Wash the air lter (18) in hot soapy water and allow to dry.
4. Lubricate the air lter (18) using a small amount of engine oil (SAE 10W-30).
5. Thoroughly squeeze the air lter (18) removing any excess oil.
6. Replace the air lter (18), and re insert the tray.
7. Secure the air lter cover (17) back using the supplied screwdriver (31)
by screwing back in the 4 screws on the side of the air lter cover in a
clockwise direction until secure.
IMPORTANT. Never run the engine without the air lter element in place.
CAUTION: Never use fuel or low burning paint solvents to clean the air lter
(18). A re or explosion could result.
CAUTION: Ensure the air lter (18) is dry before re tting.
Replacement air lters
are available from https://
help.tools/ or by calling
Customer Service on
1300 889 028
X.
Y.
To Next Page
Loading...