Always set the steam jet control to the maximum setting in the
heating-up phase in order to be able to produce enough steam.
3. Press the on/off switch
2
.
4. The appliance starts heating up and the operating light
5
lights up.
It will take about half a minute for the appliance to heat up.
5. Turn the steam jet control
5
to the required setting.
6. Switch the product off after use by pressing the on/off switch again and
pulling out the mains plug
9
.
Your steam cleaner may leave lime spots on the fl oor after some time.
Limescale can be removed with a few drops of household vinegar
or a descaling product (follow the instructions of the fl oor covering
manufacturer).
Cleaning and care
DANGER!
Risk of electric shock.
There is a risk of electric shock due to live parts.
− Always unplug the steam cleaner before cleaning,
pulling not on the cable but on the plug.
− Never immerse the steam cleaner in water or any
other liquids.
− Remove the water tank, empty it completely and rinse it out once after
each use.
− Do not use any solvents or caustic/gaseous cleaning agents to clean the
appliance’s surfaces. Wipe the surface with a damp cloth.
Washing the cleaning cloths
− Wash the cleaning cloths in the washing machine with similar colours on
a 40°C cycle.
− Do not use bleach or fabric conditioners.
18
AFTER SALES SUPPORT
AUS
Cleaning and care
AUS
1300 884 987
www.medion.com.au
To Next Page
Loading...