instructions/Adjustments and Operation/Technical data UMFl600
Saw
Stand
as described
under
point
2.
A WARNING! Ensure the mitre saw is
always stable and secure
during
opera-
tion.
(Remark:
only Mitre Saws with screw holes and a maximum weight of no more than
150 kg
should be used with
this Mitre
Saw Stand.)
Vll. Adjustments and Operation
1. Using the work
piece
stops,
Fig.
8
-
9
The roller
supports have integrated work
piece
stops
(4.114.21
that can be used for
sawing
pieces
of timber to the to the same length. Simply set to the desired length and
height.
Tighten the star knob screws firmly.
2. Use
your
bench machine as a single unit
A ATTENTION:
Remove the
mains
plug
from the Mitre Saw!
After having fitted the support brackets
(2), your
Mitre
Saw can also
be used
separate-
ly
from the universal Mitre Saw Stand.
For this
purpose, pull
the two locking
handles,
lift
the machine slightly at the rear and
push
to the front The Mitre
Saw
can now
be
removed
Vlll. Technical
data
dimension
(l
x w x h) in mm
table height in mm
roller supports height max. in mm
distance support
min. / max. in mm
saw
fitting
length max. in mm
max. loading capacity in kg
(including
the assembled
bench machine and work
pi99e)
weight in kg
1000-1650x580x810
750
910
1000
-
1650
375
150
12.5
12
E support@scheppach.com.au
MODEL:
UMF1600 PRODUCT CODE:
AFTER SALES SUPPORT
I
Grt
1300 855 831
42929 06t2017
To Next Page
Loading...