AFTER SALES SUPPORT
19
1300 855 831
support@scheppach.com.au
MODEL: HCE1400 PRODUCT CODE: 58428 11/2018
AUS
HCE1400 Assembly
VII. Assembly
m
Warning! Ensure the high pressure cleaner is correctly and completely
assembled before use.
Mounting of the handle, holder for mains cable and holder for high pressure
hose (Fig.1)
1 Mount the handle (1) onto the upper side of the high pressure cleaner and x it
with the two delivered screws by using a screwdriver (not included).
2 Slide the holder for mains cable (2) onto the connection at the side of the high
pressure cleaner.
3 Push the holder for high pressure hose (8) onto the connection at the back side
of the high pressure cleaner.
Mounting of the water inlet connector (Fig.2)
1 Remove the black cap (C) from the back side of the high pressure cleaner.
2 Mount the water inlet connector (7) at the back side of the high pressure clean-
er.
Mounting of the high pressure hose (Fig.3)
1 Remove the black cap from connection for high pressure hose (4).
2 Connect the high pressure hose (9) with the connection for high pressure hose
(4).
Mounting of the high pressure hose and the gun (Fig.4)
1 Plug the high pressure hose (9) into the gun (12).
2 For removal of the high pressure hose (9), push the lever (C) and pull out the
high pressure hose (9).
Mounting of extension with vario nozzle or patio cleaner (Fig.5)
1 Plug the extension (11) with the vario nozzle (10) into the gun (12) and twist it.
2 For mounting the patio cleaner (13), press the button (D) and remove the vario
nozzle (10). Then plug in the patio cleaner (13).
To Next Page
Loading...
