To Next Page

To Previous Page

- 4 -

- 5 -

DAY TIME SETUP (start of the day – white light):

Make sure to activate the “Day time ( )” display (see Display Setup). Press

and hold the button for 2 seconds until the hour display starts ashing.

Use the “+” and “-” buttons to set the correct hour. Press the button to

continue to the minute setting. The minute digits now start ashing. Use the

“+” and “-” buttons to set the correct minutes. Press the button to conrm

your input. You may set the day time from 4am till 2:59pm.

display

sec.

Hour “+,-” Min “+,-”

WAKE-UP TIME SETUP (alarm clock):

While setting the Day time, wake-up signal of the alarm clock may be

activated. While the hour or minute digits are ashing, press the

button; the icon will appear. The wake-up signal is now active. When the

alarm clock sounds you may turn it off by pressing any operating button,

otherwise the sound turns off automatically after 1 minute. When the key-

lock is activated, you can still turn off the alarm clock.

NIGHT TIME SETUP (start of the night – blue light):

Make sure the “Night time ( )” display is activated (see Display Setup). Press