- 3 -
TO CHARGE THE BUILT-IN BATTERY:
You may charge the built-in battery (Lithium 500mAH) using a USB cable
and a USB LPS power adaptor, computer or mobile LPS charger (not
included). While charging, make sure to keep the BC-100 and USB cable
out of reach of children.
It takes approx. 1.5 hours to fully charge the battery (depending on the
used adaptor).
The USB port is only suitable for charging the BC-100. While charging, the
red LED indicator will remain lit. The LED indicator turns to green as soon
as the battery is fully charged. The icon appears in the display when
the battery starts running empty. In this case, please charge the battery.
When using the product in a xed place, it’s advisable to use an adaptor
continuously.
DISPLAY SETUP:
The day and night time are already set in the factory.
The day time starts at 6am.
The night time starts at 6pm.
Use the button to switch between the day time display ( ), night
time display ( ) and actual time ( ).
CLOCK SETUP:
Make sure to activate the “clock ( )” display.
Press and hold the button for 2 seconds until the hour display starts
ashing. Use the “+” and “-” buttons to set the correct hour. Press the
button to continue to the minute setting, the minute display starts ashing.
Use the “+” and “-” buttons to set the correct minutes. Press the button
to conrm your input.
display
2
sec.
Hour “+,-” Min “+,-”
To Next Page
Loading...
General