INSTALLATION INFORMATION:
Attach the ceiling plate using the included plugs and screws to the ceiling on a location
of choice. Wall mounting is not recommended for smoke detection. Then put the de-
USING, TESTING AND MAINTENANCE:
Using:
The smoke detector works if it has been mounted to the ceiling. The red LED will now
the smoke disappears, the smoke alarm will stop automatically.
Time-out function:
This function will deactivate the alarm for about 10 minutes. This function can be
every 10 seconds to indicate the deactivated smoke alarm.
After 10 minutes, the alarm will be fully active once again. If there is (still) any smoke in
This function can be used repeatedly.
Test:
Hold the button for at least 2 seconds. The operation is still correct if you hear 2 or
three signal tones. Check the smoke detectors weekly. In alarm status the smoke de-
the smoke detector.
Memory function:
-
conds or so and will emit short beeps. This way you will know that the alarm has gone
to standard operation.
2
To Next Page
Loading...
Need help?
General
