Alecto WS-2300 - Page 16

Expansion:
You can register up to 3 outdoor units to the indoor unit to have the
temperature measured at 3 di󰀨erent locations (e.g. in your green-
house, pet room, di󰀨erent bedrooms, etc.). You can order additional
outdoor units via the internet at www.alecto.nl
Registering additional outdoor units:
1. slide down the battery cover at the rear of the new outdoor unit
and insert 2 AA 1.5V batteries according to the markings inside
the battery compartment.
2. just above the batteries at the rear of the outdoor unit, slide the
‘CH’ channel switch to position 2 or position 3.
3. slide the battery cover back onto the outdoor unit.
4. now repeatedly and briey press the CH at the rear of the indoor
unit until or illuminates (depending on whether you’ve
selected ‘CH-2’ or ‘CH-3’ in the outdoor unit) and then briey press
the SENSOR button.
5. the indoor unit will now start searching for the outdoor unit and as
soon as the units nd each other, the temperature will be shown
on the display of the indoor unit.
Reset/System error:
If the WS-2300 shows a possible error, you may have to reset the
indoor and outdoor unit.
1. use a sharp object to press the reset button at the rear of the
indoor unit.
2. use a sharp object to press the reset button at the rear of the
outdoor unit (for this, you’ll need to briey remove the battery
cover from the outdoor unit).
The indoor and outdoor units will then be reset and a new pairing
scan will start. After several seconds, you can continue using the
WS-2300.
If you still have no connection or sound, please contact the customer
service of Alecto via internet www.alecto.nl
16