What to do if my Aleko AC 2400 Gate Opener doesn’t run?
If your Aleko Gate Opener doesn't run, first ensure the power cord is properly plugged into the mains outlet. Also, check the fuse in the control board; if it's blown, determine why and replace it. If you're using a photocell, make sure its beam isn't blocked or that terminal 11 is shorted with terminal 12 by a jumper wire. Reset the jumper wire if it is lost.
Why does my Aleko AC 2400 Gate Opener start but immediately stop or reverse?
If your Aleko Gate Opener starts but immediately stops or reverses, the selected force may be too small. Turn the potentiometer clockwise to increase the force. Also, disconnect the gate from the operator to ensure it slides freely without any obstruction.
How to fix Aleko Gate Opener remote control that does not emit any signal?
If the remote control for your Aleko Gate Opener isn't emitting a signal, the batteries might be exhausted. Check the batteries and replace them if necessary.
Steps for placing the chain around wheels and connecting it to the opener and gate.
General| Control Type | Remote Control |
|---|---|
| Battery Backup | No |
| Max Gate Weight | 400 kg |
| Max Gate Length | 4.5 m |
| Operating Temperature | -20°C to 60°C |
To Next Page
