. .
25
PROGRAMMING
Exit: Turn the ignition switch to the ON position, or wait for 15 seconds.
3 long chirps and 3 parking light flashes will confirm the programming
was exited.
Comfort Feature:
Some vehicles have a special comfort feature. When you lock the drivers
door with the key, and hold the key in the door for 5 to 7 seconds, all the
windows in the vehicle will roll up. If you would like to operate this feature
with the remote transmitter, you can program the alarm feature # 2-1 to
COMFORT FEATURE.
Password Pin Code Setup:
1. Turn the Ignition switch ON and OFF 3 times and then leave it in
the OFF position.
ALARM FEATURE #2 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
1 0.9-second 3.5-second Double pulse Door lock with
door lock pulse door lock pulse unlock Comfort Feature
2
Ignition Ignition Ignition Without ignition
controlled door controlled door controlled door controlled door
lock & unlocks lock only unlock only lock and unlock
3
Pathway Parking light Parking light turns
illumination turns on for on for 30-seconds
feature off 30-seconds upon upon and unlock
an unlock signal signal & 10-seconds
upon a lock signal
4
Disable the out Enable the out
of range check of range check
5
+
Override with- Override with
out Password Password Pin
Pin Code Code
To Next Page
Loading...