. .
24
PROGRAMMING
Exit: Turn the ignition switch to the ON position, or wait for 15 seconds.
3 long chirps and 3 parking light flashes will confirm programming is
exited.
Active Arming With Passive Starter Disables: The Ground-when-armed
output will become active 60 seconds after the ignition is turned OFF.
The LED will flash at half its normal rate when the ignition is turned OFF
to indicate that the system will interrupt the Starter/Crank wire in 60 seconds.
45 seconds Delay Door Ajar Warning:
This feature controls the error chirp that is generated if the system is armed
with the door trigger active. This is useful in a vehicle that has a Delayed
Dome Light after the door has been closed. If the system is armed before
the dome light has turned off, the security system will generate the door
trigger error chirp. Use this feature to disable the door open error chirp.
ALARM FEATURE #2 PRORAMMING:
1.Turn the Ignition switch ON and OFF 3 times, leave it in the OFF
position.
2.Press the valet/program switch 4 times and hold the 4
th
press, hold
it in until 2 chirps followed with 1 long chirp is heard, then release the
valet/program switch. You are now in the ALARM FEATURE #2
PROGRAMMING MODE.
3.Press and release the transmitter button that corresponds to the feature
you desire to program.
ALARM FEATURE #1 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
4 45 second Instant Door
delay Door Ajar Ajar Warning
Warning
5
+ Panic with Panic with Panic with Without Panic
Ignition Ignition Ignition function
on and off on and off on and off.
Panic with no
time limit
6
+ Without Car- Active Car- Passive Car-
jack mode jack mode jack mode
To Next Page
Loading...