. .
23
Exit: Turn the ignition switch to the OFF position, or wait for 15 seconds,
3 long chirps and 3 parking light flashes will confirm you have exited
programming.
C: FEATURES PROGRAMMING: ALARM FEATURE. #1 PROGRAMMING:
1. Turn the Ignition switch ON and OFF 3 times and then leave it
in the OFF position.
2. Press the valet/program switch 2 times and on 2
nd
press, hold it
in until 1 chirp is followed by 1 long chirp then, release the switch.
You are now in the ALARM FEATURE #1 PROGRAMMING MODE.
3. Press and release the transmitter button that corresponds to the feature
you desire to program.
a. The number of chirps and LED pauses will indicate the previous
setting.
b. The factory default settings will always be [1] LED flash and [1]
chirp.
4. Press the transmitter button again to change the feature. Simply keep
re-pressing the transmitter button until the module advances to your
desired programming setting.
Example:
a. After you hear 1 chirp, press the button again and the module will
advance to [2] LED flashes and [2] horn chirps.
b. Press the button again, the module will advance to [3] LED
flashes and [3] chirps etc.
ALARM FEATURE #1 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
1 All chirps off All chirps on Siren chirp Horn chirp
on only on only
2
Active arming Passive arming Passive arming Active arming
without passive with passive with passive
door locking door locking starter disable
3
Automatic Automatic
Rearm off Rearm on
PROGRAMMING
To Next Page
Loading...