System Features ........................................................4
System Components ..................................................4
Required Tools ...........................................................4
Installation Check List...............................................4-5
Technical Assistance...................................................5
Before You Begin...................................................................5
Precautions ............................................................5-6
Using your Test Probe.................................................6
Making Wiring Connections ......................................6-8
Locating & Making Connections ..............................8-12
Connecting the 9-Pin Wiring Harness .........................13
Neutral Safety Switch ................................................14
Operator Programming Instructions .............................15-16
How to use Your Remote Transmitter..........................16
Vehicle Anti-theft System Chart..............................17-19
FCC ID Notice..........................................................20
Important Functions .............................................21-22
Your Warranty ..........................................................23
REMOTE STARTER MODEL RS90
CONTENTS
3
Protected by one or more
of the following patents:
Patent #5,459,477 Patent #5,612,670
Patent #5,886,622 Patent #5,677,664
Patent #5,942,988 Patent #6,101,428
Patent #6,452,772
Other patents pending.
82005
22
AATTENTIONTTENTION:
We urge you to immediately place this card in your wallet.
PROGRAMMING FUNCTIONS
FOR YOUR WALLET OR GLOVE
ADDING ADDING ADDITIONALADDITIONAL REMOTES USING REMOTES USING AA WORKING REMOTE WORKING REMOTE
Press and hold the brake, press and hold Button #1 on the working remote for
approx. 5 seconds or until the parking lights flash (1) one time, release button
#1 and press any button on the NEW remote, the parking lights will flash (3)
three times, the new remote is now programmed.
TTach/Tach/Tachless Optionachless Option
Press and hold the brake, with the brake held, press and hold button #2 on
the remote for approx. six (6) seconds or until the parking lights flash two (2)
times. Release button #2, press and release button #1, the parking lights will
flash one (1) time. The unit is now programmed for tach mode. Press and
release button #1 again, the parking lights will flash two (2) times. The unit is
now programmed for tachless mode.
To Next Page
Loading...