4
SYSTEM FEATURES
TTwo-Buttonwo-Button Remotely start your vehicle to run the heater or air
Extended Range
Extended Range conditioning from an extended distance.
Remote
Remote TTransmitterransmitter
Remote OptionsRemote Options Works with your factory keyless remote transmitter
or the transmitter included with this kit.
Parking LightParking Light Confirms that your vehicle has received a remote
Confirmation
Confirmation signal and will remain on if the engine is remotely
started.
Code Learning
Code Learning Allows your remote starter to learn new remotes, should
you want to add remotes, or if remotes are lost.
Remote ProgrammableRemote Programmable Unit can be programmed by remote control for a run time
Run
Run TTimeime of 5,10, or 15 minutes.
Pit S
Pit Stop Modetop Mode Allows you to exit the vehicle while the engine
remains running.
TTach/Tach/Tachlessachless A programmable feature that lets you choose between
Option
Option the easy to install tachless operation or the wire-
in, tach operation.
Limited LifetimeLimited Lifetime Guarantees life-long protection.
WWarrantyarranty
Your system includes:
1-Main Control Module
with On-board Relay
1-Two Button Remote Transmitter
1-9-Pin Wire Harness
1-Hood Pin Switch
1-Warning Sticker for Under the Hood
6-Heavy Gauge Wires
SYSTEM COMPONENTS
REQUIRED TOOLS
Unless your remote starter includes a Bonus Installation Kit you will need the
following items: a sharp knife, electrical tape and a computer-friendly test light. A
5/16 inch drill bit may be needed to install the hood pin switch. If the bottom of your
dash on the drivers side will come off, you must remove it. If this is the case a
screwdriver or a wrench may be needed.
1-Warranty
1-Installation & Operation Guide
1-Bonus Installation Kit
Installation CD Rom
Computer-friendly Test Light
Electrical Tape
Wire Ties
Razor Knife
21
INSTALLATION CHECK LIST
INSTALLATION CHECK LIST
Read the manual.
Watch the video.
Verify that you have all the parts listed in the manual.
Obtain the correct wiring chart for you vehicle.
Identify air bag and SRS wires before starting your installation.
Check to see if additional parts are needed. These items are identified in your
manual and the wiring chart diagram for your vehicle.
AATTENTIONTTENTION:
We urge you to immediately place this card in your wallet.
OPERAOPERATING INSTRUCTIONSTING INSTRUCTIONS
SSttart art Press and release button #1 the vehicle will remote start. SSttart (with factoryart (with factory
keyless entry remote) keyless entry remote) Press and release the lock button on the remote 3 times,
the vehicle will remote start. S
Stop top Press and release button #2 the vehicles
remote starter will shut down. S
Stop (with factory keyless remote) top (with factory keyless remote) Press and
release the lock button on the remote, the remote starter will shut down. Pit S
Pit Stop:top:
Exiting the VExiting the Vehicle with the Engine Running ehicle with the Engine Running Make sure the transmission is in
park, press and release button #1 (start) before turning the ignition switch off.
(The engine will remain running for the programmed run time). Pit stop:
Pit stop: (with(with
factory keyless entry remote) factory keyless entry remote) Press and release the lock button on the remote
3 times before turning the ignition switch off. (The engine will remain running for
the program run time).
OPERATING FUNCTIONS
FOR YOUR WALLET OR GLOVE
To Next Page
Loading...