Need help?Do you have a question about the Alert car security system and is the answer not in the manual?
Details the warranty coverage, repair or replacement options, and fees after the initial period.
States the disclaimer of merchantability and fitness for any particular use.
Specifies that consumer remedy is limited to repair or replacement of the unit.
Instructions for programming additional remotes using an existing working remote.
Procedure to select between tach and tachless modes for programming.
Allows remote starting of vehicle's heater or air conditioning from an extended distance.
Works with factory keyless remote or the included transmitter.
Confirms signal reception and indicates if the engine is remotely started.
Allows the remote starter to learn new remotes or replace lost ones.
Unit can be programmed for run times of 5, 10, or 15 minutes.
Allows exiting the vehicle while the engine remains running.
Feature to choose between tachless or wire-in tach operation.
Guarantees life-long protection for the product.
Provides instructions for starting, stopping, and pit stop functions.
Warns against tampering with airbag wires due to potential damage or injury.
Details special precautions for GM RWD and Dodge Dakotas regarding neutral safety switches.
Instructions for connecting two separate wires end-to-end.
Confirms the programmed run time by counting parking light flashes.
Procedure to set the desired run time for the remote starter.
Steps to clear the unit's memory and reset it to factory settings.
Guide for connecting the constant power wire to the vehicle.
Guide for connecting ignition wires to the vehicle.
Guide for connecting accessory wires to power heater/blower.
Instructions for connecting the tach input wire for tach mode operation.
Connecting the blue wire for auxiliary input with aftermarket alarms.
Connecting the blue wire for factory keyless entry or aftermarket alarms.
Connecting the bypass output wire for security bypass modules.
Procedure to add remotes using a working remote.
Procedure to add remotes without a working remote.
Selecting Tach or Tachless mode for the system.
Instructions for programming the tach learn function.
Instructions to program the system to start using a factory keyless entry remote.
Instructions for programming the system for aftermarket alarm starting.
Details on using auxiliary inputs for alarms.
Explains the mechanical neutral safety switch operation for older GM/Dodge vehicles.
Wiring instructions for pre-1996 GM RWD vehicles with purple crank wire.
Wiring instructions for pre-1996 Dodge Dakotas.
Guide for connecting the brake input wire.
Instructions for optimal placement of the antenna.
Connecting the factory alarm shut down wire.
Instructions for installing and connecting the hood pin switch.
Optional connection for tach input wire for tach mode.
Connecting the blue wire for auxiliary input with aftermarket alarms.
Connecting the blue wire for factory keyless entry or aftermarket alarms.
Connecting the bypass output wire for security bypass modules.
Procedure to initialize the control module and code transmitters.
Steps for the initial programming sequence involving brake pedal and remote button.
Highlights the necessity of this procedure if a remote is lost or memory is cleared.
Troubleshooting steps if the vehicle does not start after remote activation.
To Next Page
General