Chapter 1 – Your First Session with the MIDIVerb 4
16 MidiVerb 4 Reference Manual
Bypassing Effects
At any time you can bypass the effects, thereby allowing the direct signal to pass
through the MidiVerb 4 unchanged. This can be done in two ways:
• by simultaneously pressing both the [PROG] and [UTIL] buttons on the front
panel; or,
• by connecting a footswitch to the [FOOTSWITCH] jack and pressing the
footswitch. This requires that the [FOOTSWITCH] jack be set to trigger the
Bypass function, which is located among the UTILity functions.
Each time the [PROG] and [UTIL] buttons are pressed, or the footswitch connected to
the [FOOTSWITCH] jack is pressed, Bypass mode is toggled on and off again. When
Bypass mode is turned on, the [BYPASS] LED will be lit.
To set the [FOOTSWITCH] jack to the Bypass function:
➀ Press [UTIL].
The [UTIL] button will light.
➁ Press [EDIT/PAGE] until page 1 is selected.
The display will read:
Footswitch Dry Defeat
➂ Press [B] to select the Footswitch parameter.
➃ Turn the [VALUE] knob to set the Footswitch parameter to Bypass mode (bYP).
To Next Page
Loading...
