Alesis DM Pro - How to Adjust the Panning of a Drum

12
How to Adjust the Panning of a Drum
P2: Drum Pan
• To adjust the pan position of a Drum assigned to a MIDI Note, move
the cursor beneath the Drum Pan Parameter Value:
Drum Pan: PROG
Note:83 B4
P2
• Now turn the Value encoder to change the MIDI Note’s pan position.
There are eight possible Values for the Drum Pan Parameter:
<3 Hard left
<2 Moderately left
<1 Slightly left
<> Center
1> Slightly right
2> Moderately right
3> Hard right
PROG Pan position determined by the Drum
• In the final position, PROG, the Drum’s pan position
as it was
programmed in Drum Edit Mode
determines the Pan position.
Note that MIDI Pan controller has 128 increments (0 - 127) and the DM
Pro only has seven positions. The following chart shows the MIDI-to-
DM Pro value equivalents:
DM Pro Value Pan Position MIDI CC #10 Value
<3 Hard left 00
<2 Moderately left 21
<1 Slightly left 42
<> Center 63
1> Slightly right 84
2> Moderately right 106
3> Hard right 127
Remember, if you send MIDI Panning commands to the DM Pro’s Basic
MIDI Channel, the pan position of the entire Drumkit will change. For
individual Pan control over certain Drums, use the Drum Channel
Override parameter as discussed on page 7 of the Basic User Guide.