6
USING MULTIMIX 10 WIRELESS FOR MULTITRACK AUDIO RECORDING
The Insert jack can also be used as a direct output to a multitrack recorder. The ‘Send’ provides the cleanest mic
preamp signal by sending the signal to the recorder prior to it reaching the mixer’s EQ and channel fader. Use a
standard TRS cable and insert the plug on the mixer’s side only until the first “click” (the ring connector). This will
send the preamp signal to the recorder without interrupting the normal signal flow through the mixer.
PAIRING A BLUETOOTH DEVICE
1. Turn on your Bluetooth device.
2. Power on MultiMix 10 Wireless.
3. Press the Pair/Unpair button on MultiMix 10 Wireless.
Note: You can pair with an iPhone®, iPad®, computer (Mac/PC), or Android device equipped with Bluetooth that
supports A2DP. Android users should consider updating their OS if experiencing trouble with pairing or playing
music.
4. Navigate to your Bluetooth device’s setup screen, find “Alesis MultiMix” and connect.
Note: If your Bluetooth device prompts for a pairing code, enter ‘0000’.
5. MultiMix 10 Wireless’s pairing LED will light up solid when it is 'paired'.
Note: If your Bluetooth device is not able to pair to the mixer, press the Pair/Unpair button on the mixer to break
previous Bluetooth connections and reset the Bluetooth module.
6. To disconnect pairing, press the Pair/Unpair button on MultiMix 10 Wireless.
7. To connect to a different Bluetooth device, repeat steps 4-5.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.
“Insert” Connector (to MultiMix 10 Wireless)
“Send” Connector
(to External Device’s Input)
“Return” Connector
(From External Device’s Output)
iPad and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries.
Android is a trademark of Google Inc.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
