Part 6: Editing Effects
QS7.1/QS8.1 Reference Manual 83
MOD1 LEVEL
Range of Settings: -99 to 99 Page 3
This decides the degree to which the Destination will be modulated by the selected
Source. Please notice the setting range, which allows you to choose both negative and
positive numbers. Don’t be daunted by that — the way it works is very clear in
practice.
Here’s an example. Assume that Reverb Decay is the Destination, and Mod Wheel is
the Source. In that situation, a positive Level setting would let you increase decay time
by moving the Mod Wheel up; while a negative setting would let you decrease decay
time using exactly the same motion.
MOD2 SOURCE
Range of Settings: (see list) Page 4
This works the same as described for Mod 1 Source, above, but for the second
possible modulation route.
MOD2 DESTINATION
Range of Settings: (see list) Page 5
This works the same as described for Mod 1 Destination, above, but for the second
possible modulation route.
MOD2 LEVEL
Range of Settings: -99 to 99 Page 6
This works the same as described for Mod 1 Level, above, but for the second possible
modulation route.
To Next Page
Loading...
Need help?
General
