Mix Mode
50 QuadraSynth Reference Manual
CH SOLO. In this mode, the only sounds coming from the QuadraSynth, and the
only MIDI Out messages, will come from the layer or range of the underlined MIDI
channel in the display. This allows you to isolate individual channels in a Mix. So, if
you play in a range of the keyboard that is active on MIDI CH 1, and 1 is underlined,
you'll hear it. All other ranges or layers will not respond to the keyboard (they will
continue to respond to incoming MIDI messages on their respective channels,
however).
Use the MIDI [¬] and [®] buttons to hear each channel in turn.
OUT 1 Ñ OUT 16. The QuadraSynth will generate MIDI messages from the
keyboard, regardless of the Range settings for that channel in the Mix, but it will not
play the internal sound. Use this mode if you're using a MIDI sequencer with an
ECHO feature--the sound will be activated by messages appearing at the MIDI IN
connector after itÕs made the Òround tripÓ through the sequencer. This is the
QuadraSynthÕs equivalent to LOCAL OFF.
To Next Page
Loading...
