This schedule is the recommended application for a single user, up to 20~30 minutes per time. It should be 3~4 times per week. For
lubrication, you can contact your dealer.
CLEANING
Perspiration should be wiped from the console and treadmill surface after your workout.
You should wipe down your treadmill once a week with a water dampened, soft cloth. Be careful not get excessive moisture on the
display panel as this might cause an electrical hazard or electronics to fail.
STORAGE
Store your treadmill in a clean and dry environment. Ensure the master power switch is off and is un-unplugged from the electrical
wall outlet.
MOVING
This treadmill has been designed and equipped with wheels for easy mobility. Before moving, ensure the master power switch is in
the off position and the power cord is unplugged from the electrical outlet.
FOR CONSUMER/HOME USE ONLY!!
This treadmill is designed for home use only. Do not use for light institutional or commercial.
LUBRICATION
It is important to take good care of your treadmill deck (the walking surface underneath the belt).A good silicone lubrication will also
improve the performance of your treadmill.
NOTE: Use the silicone that is supplied with the treadmill. Additional silicone lubricant can be purchased from your retail store.
WARNING: STOP the treadmill and remove the safety key before lubricating the running deck.
HOW TO SPRAY SILICONE ON DECK?
A). Find the silicone bottle. It is located in the hardware kit package included with this treadmill.
B). Find a straw and put it onto the silicone bottle as the drawing shows.
C). Spray silicone evenly on treadmill deck as the drawing shows. (ATTENTION: The treadmill MUST
BE STOPPED before applying the silicone lubricant. This is to prevent injury, otherwise the edge of the running belt may cut you or
your fingers could be crushed by the rollers. )
Do not put too much silicone on the deck. Excessive lubricant may cause slippage of the belt on the rollers.
HOW TO SPRAY SILICONE ON DECK?
1. Speed error signal: “OVER SPEED”
Solution: 1). Adjust the position of speed sensor wire
2) Replace the speed sensor wire
2. The safety key is not connected: “SAFETY KEY OFF”
Solution: 1）Adjust the position of the safety key.
2) Replace the switching line of safety key.
12
To Next Page
Loading...