Algoma Net 6800 - Before Assembling

PARTS LIST (continued)
PACKAGE CONTENTS
B
C
F
G
Part Description Qty Part Description Qty Part Description Qty
A Plastic Feet 4 G Foot end Stand Support 1 M
Canopy Middle
Support
1
B Long Leg Braces 2 H Fabric Canopy 1 N
Hanging Chains with
Lock Hooks
4
C Leg Cross Braces 2 I
Canopy Upright
Supports
2 O
Hammock Bed With
Attached Pillow
1
D
Plastic Leg Joint
Protectors
4 J
Canopy Frame End
Support Base
1 P
Fabric Chain
Protectors
4
E Uprights 4 K Canopy Frame Sides 2
F
Head end Stand
Support
1 L
Canopy Frame End
Support Front
1
BEFORE ASSEMBLING
• Place all parts from box in a cleared area and position them on the ground or floor in front of
you.
• Remove all packaging materials from your area and place them back into the box.
• Do not dispose of the packing materials until assembly is complete.
• Read each step carefully before beginning.
• Item is heavy. Handle with care.
• Although assembly can be done with one person, a second person will make assembly easier.
• Make sure all lock-pins are completely inserted and engaged into the appropriate lock-pin
holes.
Estimated Assembly Time: 30 minutes
SECURING FOR SAFE USE
• After you have finished assembling the hammock, go back over the entire unit to make sure all
lock-pins are fully engaged and hardware is locked onto hammock stand. Repeat this
procedure prior to any use.
• Do not use the canopy in windy conditions. The wind could cause the canopy to blow off or
put excessive wear on the canopy attachments resulting in its failure. The hammock lounge
can be used without the canopy by removing the entire canopy frame from the head end stand
support.