Algoma Net 6800

To Next Page

To Previous Page

ASSEMBLY INSTRUCTIONS

STEP 1

Locate the 4 plastic foot pieces (PartA), and place onto the ends of the 2 long leg braces (Part B)

Part A Part A

Part B

STEP 2

Place the completed leg sections across from each other with the side protrusions facing each

other. Locate the 2 leg cross braces(Part C) and insert each end into the side protrusions

located on Part B making sure the lock-pin aligns with the hole and become fully engaged

through the lock-pin hole.

Part B

Part C

Step 2 Completed

STEP 3

Locate the 4 plastic leg joint protectors (Part D). Place one on each of the upright protrusions on

leg brace (Part B) aligning the hole in Part D over the hole in the upright protrusion.

Part D

Part D in place

Algoma Net 6800 - Page 5