This document is a user manual for an Alien E-Bike, providing comprehensive information on its assembly, operation, maintenance, and warranty.
Function Description:
The Alien E-Bike is an electric bicycle designed for ease, luxury, and mobility. It offers an environmentally friendly alternative to gas-powered vehicles, aiming to provide an enjoyable riding experience with pedal-assist modes and multiple gears. The E-bike can be used for various purposes, including commuting and recreational riding, with features designed to enhance safety and comfort.
Important Technical Specifications:
- Tire Pressure: Recommended 18-25 psi (check side of tire for exact specification).
- Battery: Rechargeable, with a charging time of 3 to 7 hours for a full charge. The charger has a red LED for charging and a green LED for fully charged.
- Gears: Equipped with multiple gears for different speeds and power. The rear wheel typically has 7 or 9 chain sprockets, depending on the model. Some models may have a front derailleur with one or three gears.
- Pedal Assist System (PAS): Offers 5 modes:
- PAS 0: Full display, no throttle or power assistance (some models may not have a 0 mode).
- PAS 1: Low speed level.
- PAS 2: Low/Medium speed level.
- PAS 3: Medium/High speed level.
- PAS 4: High speed level.
- PAS 5: Maximum speed level.
- Brakes: Equipped with brake levers that have a built-in safety switch to automatically cut off motor power under normal braking conditions. Disc brakes are used.
- Battery Range: Standard battery lasts about 40-60 km depending on factors like pedal assist level, terrain, rider weight, temperature, and tire pressure.
- Motor: The motor is protected by a built-in safety switch that cuts off power when brakes are applied.
Usage Features:
- Power On/Off: To turn on, turn the ignition key to the right and hold the middle button (or bottom button on some models) for 2 seconds until the display powers up.
- Handlebar Controls:
- Left Handlebar: Rear brake lever, left handlebar grip, headlight button, phone holder, pedal assist button (selects modes 1-5), front derailleur shifter (if applicable, for 1 or 3 gears).
- Right Handlebar: Rear derailleur shifter (increases gears from 1 to 7 by pressing a button, decreases gears from 7 to 1 by pressing a lever), brake lever, LCD display, anti-slip handlebar, right handlebar grip, ignition key.
- Folding Frame: The E-bike features a folding frame for portability and storage. To fold, push the release latch forward while pulling the folding clasp.
- Battery Removal: The battery can be removed for charging or for Y20 models, turn the key and remove the battery.
- Pedal & Saddle Adjustment: Pedals are labeled L (left) and R (right) and screw into the crank. The saddle height can be adjusted, ensuring the minimum safety line is not visible.
- Headlight & Front Wheel Assembly: The headlight can be adjusted, and the front wheel is secured with a quick-release mechanism.
- Keys: Comes with one or two keys (plus one spare). The key is used for ignition and for the battery holder on the bicycle frame. Keep keys out of reach of children and in a safe place to avoid losing them.
Maintenance Features:
- Regular Inspections (Before Every Ride):
- Tire pressure (18-25 psi).
- Tire wear/damage.
- Brake pad adjustment.
- Wheel quick adjustment.
- Head & tail lights.
- Controls & displays.
- Seat post quick release adjustment.
- Periodic Inspections (Every 5-10 rides):
- Brake pad wear.
- Brake cable tension wear.
- Spoke tension.
- Wheel true.
- Hub bearings.
- Chain lubrication.
- Derailleur adjustment.
- Reflectors.
- Battery & charger.
- Headset adjustment.
- Bottom bracket adjustment.
- All bolts, nuts & mounting hardware.
- Cleaning: Periodically clean the E-bike with a damp cloth. Avoid spraying electrical parts directly with water. Store in a dry, sheltered area away from direct sunlight and wet or damp environments.
- Battery Care:
- Recharge the battery after every use.
- Store in a cool, dry place and recharge every 2 months if not used for an extended period.
- Do not disassemble or alter the battery or charger.
- Do not place the battery near fire or corrosive substances.
- Do not allow any liquids on or inside the battery or charger.
- Do not expose the battery or charger to extreme weather conditions.
- Do not operate the battery or charger if damaged.
- Recharge the battery only with the charger specified by the manufacturer.
- Never leave the battery charger plugged in and unattended for more than 10 hours.
- Gears Maintenance: Adjustments require fine tuning and should only be performed by a qualified technician. Avoid changing gears rapidly or while going uphill to prevent damage to the chain.
- Brakes Maintenance: Regularly check brake cable tension and brake pad wear. Disc rotors can become hot, so avoid contact after use. Wet weather can increase stopping distance.
- Low Voltage Protection: The electronic control system will cut off power to automatically protect the battery when it reaches its minimum voltage. The battery should be recharged before riding again.
- Charge Indicator: Red indicates charging, green indicates full.
- Battery Switch: The battery switch must be turned off when not in use. The battery must be fully charged before first use and after 3 uses.
- Basic Maintenance Checklist:
- Maintain and clean regularly.
- Regularly check tires for inflation.
- Ensure quick release nuts and bolts are tightened properly.
- Periodically check spoke tension.
- Inspect frame and other parts for abrasion/collision.
- Do not open or take apart the battery, motor, or controller.
- Do not use a high-pressure hose to clean the E-bike.
- Lubricate the chain, flywheel, head parts, kickstand, etc. when necessary.
- Warranty Period: 12 months (or shorter if indicated for clearance) from the delivery date.
- Exclusions: Damage caused by modification, alteration, unauthorized repair, mishandling, Acts of God, external bodies, other devices, accidents, misuse, abuse, tampering, or failure to follow normal operating procedures. General maintenance and servicing are also excluded.
- Validity: Warranty is valid only when the product is purchased from an authorized dealer or outlet with proof of purchase. It is non-transferable.
- Warranty Claims: If the E-bike is received with a defect, shipping fees for repair/replacement are covered. For repairs, contact the retailer to obtain a Return Authorization (RA) number. All returns must be properly packaged. The RA number must be clearly visible. The owner is responsible for insurance if the merchandise is lost or damaged during shipping.
- Non-Transferable Warranties: Excludes replacement and shipping costs of products worn out by normal use, and replacement and shipping costs of products due to problems related to neglect, abuse, or lack of maintenance.
The manual also includes sections for recording vehicle identification number, serial number, owner's name, address, purchase date, model, color, and serial number. A QR code is provided for warranty and serial number registration.
Need help?
To Next Page
General