13. After then, please enter to "Setup Information" to double check and confirm all the settings
correction.
多軸機類型與感度設定完成後，請至〔機體設定資訊〕內檢查相關資訊是否設置正確。
14. Finally, please enter to "Transmitter Channel Setup" and adjust transmitter stick direction and
calibration.
以上步驟皆設置完成後，再進入〔遙控器動作設定〕，調整遙控器搖桿方向、行程校正
a. Before starting, set all EPA / Travel ADJ max and min value on your TX to default 100%,
and neutralize all subtrims to 0.
設定此項目前，所有頻道 EPA、Travel ADJ 最大最小要為預設值 100%，所有微調設為"0"。
10
To Next Page
Loading...