Alinco DR-130 - SPECIFICATIONS; General Specifications; Transmitter Specifications; Receiver Specifications

SPECIFICATIONS
1) General
Frequency Coverage:
RX: 136.000 ~ 174.000MHz (T version)
TX: 144.000 ~ 148.000MHz (T version)
RX: 144.000 ~ 146.000MHz (E/EZ version)
TX: 144.000 ~ 146.000MHz (E/EZ version)
RX: 130.000 ~ 174.000MHz (EA/TA version)
TX: 130.000 ~ 174.000MHz (EA/TA version)
RX: 136.000 ~ 155.000MHz (TE1 version)
TX: 136.000 ~ 155.000MHz (TE1 version)
RX: 150.000 ~ 174.000MHz (TE2 version)
TX: 150.000 ~ 174.000MHz (TE2 version)
Frequency Resolution: 5, 10, 12.5, 15,20,25kHzsteps
Antenna Impedance: 50 ohm unbalanced
Power Supply Requirements
:
DC 13.8 +/-10% Volts DC
Current Drain at l3.8V
Receiving: Squelched less than 800mA
Transmitting: High/10.0A (approx.)
Low/3.5A (approx.)
Dimensions: 140mm(W) x 40mm(H) x 154mm(D)
Weight: 0.86kg (approx.)
2) Transmitter High: 50Watts (DR-130T/E)
Output Power: High: 35Watts (DR-130TE1/2)
High:10Watts (DR-130EZ)
Low: 5Watts (Approx.)
Emission Mode: F3E(FM)
Modulation System: Variable Reactance Frequency Modulation
Max. Frequency Deviation: +/ -5kHz (Wide Version)
+/ -2.5kHz (Narrow Version)
Spurious Emission: -60dB or below carrier
Microphone: Electret Condenser Microphone
Operating Mode: Simplex/Semi-Duplex
Offset : 0ffset from 0 to 15.995MHz
3) Receiver
Receiving System: Superheterodyne Dual Conversion
Intermediate Frequency: 1stIF: 17.2MHz
2nd lF: 455kHz
12dB SINAD less than -l6dBu (144.000MHz ~ 147.995MHz)
Sensitivity: More than +/-6kHz at -6dB (Wide Version)
Selectivity: Less than +/-15kHz at -60dB (Wide Version)
Audio Power Output: More than 2.5W 10% Distortion
Speaker Impedance: 8 ohm
Page-2