11-07-03 Z08-00489A
15. Do not start the machine unless the gun
assembly is firmly gripped by the machine
operator. Failure to do this could result in injury
from a flying hose and gun assembly.
16. Always point the gun assembly in a safe
direction and do not direct spray on the cleaner
or personnel in the area.
17. Always shut down machine before refueling.
18. Do not overfill the fuel tank. If any spillage
occurs, clean up immediately and/or neutralize
the spill before attempting to operate the
machine.
MECHANICAL SAFETY
1. All guards, shields, and covers must be replaced
after adjustments are made to prevent
accidental contact with hazardous parts.
2. Drive belts must be inspected and tightened
periodically to operate at optimum levels.
3. Inspect machine for damaged or worn
components and repair or replace to avoid
potential hazards. Do not operate the machine
if any mechanical failure is noted or suspected.
4. Always use the correct size spray tip found in
the GENERAL section of the MODEL
SPECIFICATIONS or MODEL EXPLODED
VIEW.
5. DO NOT start the engine until you have
observed all safety and operating instructions
found in the engine manual..
FUEL SAFETY
1. Use only #1 or #2 diesel fuel for the water heater
burner. The use of incorrect fuel may result in
fire or explosion and severe injury to the
operator.
2. Do not refuel machine while it is running or
hot. Allow it to cool sufficiently to prevent
ignition of any spilled fuel. Clean up any spilled
fuel before resuming operation.
3. Fuel burning equipment must have proper
ventilation for cooling, combustion air, and
exhausting of combustion products.
4. Stacking, where required, must be installed in
accordance with all local codes. A draft
diverter must be installed on a machine
connected to an exhaust stack to prevent
improper operation. (See GENERAL section of
MODEL SPECIFICATIONS for stack size).
5. Where stacking is not required, provide
adequate ventilations to prevent any possible
accumulation of hazardous fumes.
6. Personnel trained in and familiar with the type
of equipment being serviced should only
perform adjustments to fuel burning
equipment.
SAVE THESE SAFETY
INSTRUCTIONS
WARNING: DO NOT USE GASOLINE,
CRANKCASE DRAININGS, OR OIL
CONTAINING GASOLINE OR SOLVENTS.
AVERTISSEMENT: NE PAS UTILISER
D’ESSENCE DE PRODUITS DE VIDANGE
NI D’HUILE CONTENANT DE L’ESSENCE
OU DES SOLVANTS
WARNING: OPEN FLAME. Do not operate
this machine in an area with combustible
materials. A suitable fire extinguisher
should be available in operating area.
4
WARNING: RISK OF INJECTION OR
SEVERE INJURY. KEEP CLEAR OF
NOZZLE. DO NOT DIRECT DISCHARGE
STREAM AT PERSONS. THIS EQUIPMENT
IS TO BE USED ONLY BY TRAINED
OPERATORS.
AVERTISSEMENT:RISQUE
D’INJECTION ET DE BLESSURES
GRAVES. SE TENIR À L’ÉCART DU JET. NE
PAS DIRIGER LE JET DE SOTIE VERS
D’AUTRES PERSONNES CONFIER
L’UTILISATION LE JET DE SOTIE VERS
D’AUTRES PERSONNES. CONFIER
L’UTILISATION DE CE MATÉRIEL À UN
ECN-03022Supersedes 02-12-01 Z08-00489A
To Next Page
