Need help?Do you have a question about the ALL-FILL B-SV-600 and is the answer not in the manual?
Covers the physical and functional aspects of the touch screen control panel.
Explains the use of START/STOP, PAUSE, and EXIT buttons for machine control.
Details the control power switch, power indicator, and reset switch functionality.
Single line messages indicating the current operational state of the filler.
Describes the interactive, English-language menus for operational control.
Procedure for starting and verifying correct machine operation after installation.
How to access and utilize test functions for components and devices.
Procedure to select and store up to 50 different setup run programs.
Associating product, batch, or lot with a specific Setup Program.
Defining the desired final filled weight for the product.
Choosing the type of feedback (Servo, A&D Scale, None) for fill weight correction.
Defines the amount of product dispensed per fill cycle based on auger revolutions.
Selects the operating speed for the servo fill motor.
Controls product agitation on/off and speed during filling.
Delays turning agitation off to accommodate high cycle rates.
Controls product cutoff devices at the filler funnel (None, Time, Limit Switch).
Sets a delay after a fill cycle for coordination or settling.
Configures operation of the Level Control switch for hopper re-supply.
Configures product infeed equipment signals (Pulse, Continuous, None).
Verifies hopper product and availability of empty containers.
Procedure to turn power on, select programs, and start the filling process.
Provides summaries of filling production totals and operational data.
Accesses setup selections and settings for tuning during filling production.
Access to setup programs and service functions for production.
Access to machine testing, reset production stats, and EOF signal functions.
Define product name, target filling weight, and feedback operation.
Configure auger revolutions and agitator drive operation.
Control cutoff device and select delay after fill.
Specify level control and product infeed operation.
Operate auger and agitator for testing and adjustment.
Test cutoff, product re-supply, and EOF/Run signals.
Verify feedback functions and settings for servo and scale.
Reference for all major touch screen selections and entries.
Template for recording setup program selections and entries.
General| Type | Control Panel |
|---|---|
| Model | B-SV-600 |
| Manufacturer | ALL-FILL |
| IP Rating | IP65 |
| Communication Interface | Ethernet |
| Operating Temperature | 50°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | non-condensing |
To Next Page
