Need help?Do you have a question about the ALL-FILL B-350Touch and is the answer not in the manual?
General| Brand | ALL-FILL |
|---|---|
| Model | B-350Touch |
| Category | Control Panel |
| Language | English |
General description of the controls on the Model B-350Touch Control Panel.
Procedures for using the Emergency Stop and Reset switches for safety and system reset.
Green lamp indicating control power availability.
Explains how to control and operate the All-Fill filler using the control panel.
Description of key elements on the Main Screen like Stop/Run and Recipe selection.
Displays production counts, CPM, and recipe selection access.
Explains Product Level, Agitator, Cutoff indicators and Auger Revolutions display.
Visual indication of filler and control functioning via graphics.
Displays current operation messages and actions.
Lists all screens and selections controlled by the touch panel.
Overview of Recycle, Recipe, Product Level, Agitator, Cutoff, and Auger menus.
Accesses Test Auger, Test Outputs, and Test Inputs screens for diagnostics.
Procedures for testing Auger, Outputs, and Inputs.
Guides on starting and operating the filler after installation.
Uses Test Menu to operate and test various components and devices.
Procedures for jogging the auger and testing the agitator.
Stores and identifies up to 10 setup programs for different products.
Selects the type of recycling operation for the Model B-350Touch.
Configures filling by revolutions or duration and sets auger revolutions.
Controls agitator operation and cutoff device function.
Configures cutoff operation using time or limit switch settings.
Manages hopper resupply from external equipment using level control.
Enters and verifies product and accessory types for setup recipes.
General guidelines for starting up and shutting down the auger filler.
Provides centralized control and access to other screens and selections.
Displays production counts, CPM, and recipe selection access.
Explains Product Level, Agitator, Cutoff indicators and their menus.
Displays auger revolutions and provides access to the Auger Revolution Menu.
Visual indication of filler and control functioning via graphics.
Provides selections for automatic recycling and language settings.
Selection to turn automatic recycling on or off.
Configuration for recycle time and resetting production counts.
Settings for recipe identification and product naming.
Settings for auger revolutions per cycle and product agitation.
Provides selections for hopper resupply from a bulk source.
Specifies how the hopper is re-supplied with product from infeed equipment.
Manages infeed equipment activation and pause delays for low product levels.
Provides selections to control the product agitator blade and its operation.
Delays agitation turn-off to assist product movement and reduce wear.
Provides selections to control a product cutoff device and its timing.
Specifies opening and closing delays of the cutoff.
Accesses fill type, auger revolutions, and delay after fill settings.
Configuration for fill type, revolutions, and time duration.
Variable delay after fill for product to settle, avoiding spillage.
Lists product and accessory types for setup recipes.
Accesses Test Auger screen for operating and testing fill/agitator motors.
Operates the auger to remove material from the hopper for cleaning/servicing.
Tests operation of the filling machine's agitator blade and drive components.
Operates cutoff and product request/end of fill signals to external equipment.
Tests Product Request and End Of Fill signals for external equipment.
Displays input signals like Emergency Switch, Foot Switch, etc.
A worksheet to help develop and record setup selections and entries.
To Next Page
