The following is a step-by-step list of converting from L.P. Gas to Natural Gas or from natural Gas
to L.P.
1. Remove the top panel in the back from the Grill to gain access to the regulator
2. Remove the existing regulator and install the appropriate regulator provided by ALLEGRA
manufacturer, and corresponding with the gas type.
3. Remove the Grill's cooking grids and burners. Be cautious and do not move or damage the
electrodes on the igniter.
4. At the entrance of the burner throat find the main burner orifices. Unscrew these orifices and
put them aside.
5. Replace EACH INDIVIDUAL ORIFICE WITH THE SPECIFIED ORIFICE provided by American Heating
Technologies Inc. (You must replace the main burner orifices, back burner orifice and side
burner orifices.)
6. Refit the access panel in the back of the grill
7. Attach the main burners onto the burner valve orifices. Do not damage or move the igniter
electrodes.
8. After correctly converting the Grill and testing for leaks, follow the instructions for lighting the
grill and check the burner flames for possible irregularities (color, look, etc.)
9. Adjust the burner "Low" setting by using a long stemmed flat-head screwdriver, inserting the
screwdriver into the Burner Control Valve, and turn the adjustment screw producing a stable
flame when the Burner Control Valve is set on "low."
This applies to all operations / burner types.
10. If the burner is running properly, place the cooking grids back in position.
11. To indicate the change made, make sure to mark the proper setting on the rating plate.)
CONVERSIONS
WARNING
WHEN CONVERTING A UNIT GAS TYPE YOU MUST ONLY USE A
CONVERSION KIT SPECIFIED BY AMERICAN HEATING TECHNOLOGIES INC.
PAGE 22
To Next Page