ALLEN & HEATH dLive CDM32 - Rear Panel Connections

MixRack Getting Started Guide
8
AP10643 Issue 2
3. Rear Panel
Mic/Line inputs - Recallable preamps for balanced or unbalanced
microphone and line level signals. Gain, Pad and 48V are digitally controlled within
the preamp.
The PP indicator lights up when phantom power voltage is detected at the socket,
whether internally or externally sourced.
Any socket can be patched to any Input Channel using the I/O or Processing /
Preamp screen.
Line outputs – Line level, balanced XLR outputs. Nominal level +4dBu. The
outputs are relay protected to prevent power on or off thumps.
Signals can be patched to any output socket using the I/O screen.
I/O Port – Audio interface port providing 128x128 channels. Fit one of the
option cards available for system expansion, digital mic splitting, recording or
distributed audio networking. Refer to for a list of available
option cards.
 iLive / GLD option cards (M-Dante, M-Waves, M-ES-V2, M-ACE, M-MADI) can be
used with dLive when fitted with the M-DL-ADAPT ‘letter-box’ adapter. This
provides a 64x64 48kHz interface with built-in Sample Rate Conversion.
Use the I/O screen to patch signals from or to the I/O Port.
Control Network
Secondary
ALLEN
Primary
Lnk/ActLnk/Act
GigE
Lnk/Act
HEATH
&
1
2
3
10
3
2
1
11
5
6
4
8
7
9
9