USB-to-DeviceNet Cable 3
Rockwell Automation Publication 1784-IN046D-EN-P - April 2011
Environment and Enclosure
ATTENTION: This equipment is intended for use in overvoltage
Category II applications (as defined in IEC 60664-1), at altitudes up
to 2000 m (6562 ft) without derating.
This equipment is considered Group 1, Class A industrial equipment
according to IEC/CISPR 11. Without appropriate precautions, there
may be potential difficulties with electromagnetic compatibility in
residential and other environments due to conducted and radiated
disturbances.
This equipment is supplied as enclosed equipment. It should not
require additional system enclosure when used in locations consistent
with the enclosure type ratings stated in the Specifications section of
this publication. Subsequent sections of this publication may contain
additional information regarding specific enclosure type ratings,
beyond what this product provides, that are required to comply with
certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, ,
publication 1770-4.1
, for additional installation requirements
• NEMA Standard 250 and IEC 60529, as applicable, for
explanations of the degrees of protection provided by enclosures
At the end of its life, this equipment should be collected
separately from any unsorted municipal waste.
To Next Page
Loading...
Need help?
General
