Need help?Do you have a question about the Allen-Bradley 22C-D6P0N103 and is the answer not in the manual?
General| Input Voltage | 480V AC |
|---|---|
| Amperage | 6.0 A |
| Certifications | cULus, CE, C-Tick |
| Enclosure | Open |
| Communications | EtherNet/IP |
| Serial Port | RS-485 |
Guidelines for proper drive mounting, including torque and environmental factors.
Outlines essential requirements for safely connecting the drive to system ground.
Recommendations for input fuses and circuit breakers for branch circuit protection.
Details on suitable unshielded and shielded motor cable types for drive installations.
How to control the drive's start, stop, direction, and speed using the integral keypad.
Steps to follow before applying power to the drive for initial setup.
How to control the drive's start, stop, direction, and speed using the integral keypad.
Instructions on how to navigate and modify drive parameters using the integral keypad.
Information on drive fault types, descriptions, and their causes.
Step-by-step instructions for clearing drive faults using the keypad.
Detailed descriptions of various drive fault types, their causes, and corrective actions.
Troubleshooting guide for common drive symptoms and their corresponding corrective actions.
Troubleshooting steps for issues related to terminal block start/run inputs.
Troubleshooting steps for issues preventing the drive from starting via the integral keypad.
Steps to diagnose why the drive is not responding to speed command changes.
Solutions for issues where the motor or drive fails to accelerate to the target speed.
Steps to diagnose and resolve issues preventing the drive from powering up.
Recommended AC line input fuse and circuit breaker information for protection.
Information on configuring and using the drive's built-in PID control loop.
Step-by-step guidance on tuning the PID proportional, integral, and differential gains for optimal performance.
Information on enabling and configuring the auxiliary motor control feature for multi-motor systems.
Instructions on how to read and write parameter values using Metasys configurable objects.
Instructions on using P1 configurable points to read and write parameter values.
How to write parameter values to the drive using P1 configurable output points.
To Next Page