Publication 1785-IN022C-EN-P - September 2005
Firmware Update Instructions for Ethernet, Enhanced and ControlNet PLC-5 Programmable Controllers 17
4. Remove power from the controller.
5. Remove the controller from the chassis.
3F - Start the firmware update.
Click Yes.
The progress indicator shows how much of the
update has been performed.
Important: This update will take approximately
13 minutes to complete.
3G - Follow the power cycle instructions during and after the update process.
When the update is complete, the software will prompt
you to cycle power.
Important: If you are updating the firmware EPROM on
the communication card, you must first complete the
next three steps:
- “Install the New Firmware EPROMS”
- “Apply the Firmware Revision Label”
- “Complete the Firmware Update”
If you are not updating the firmware EPROM on the
communication card, skip to step 5 “Apply the
Firmware Revision Label”.
These procedures are detailed on the following pages.
Allen-Bradley Motors
To Next Page
Loading...
