Publication 2711P-UM001A-EN-P
Using Configuration Mode 4-29
Startup Tests Settings
From the Startup Tests Settings screen, you can:
• enable extended diagnostics to run on the terminal at startup
• disable extended diagnostics at startup
• specify how many times to repeat the selected tests that are run
on the terminal during startup.
The Repeat Count field shows the current value. You can enter a value
in the range of 0 - 128.
IMPORTANT
Enabling Extended Diagnostics and setting a high
Repeat Count will increase the time it takes the
terminal to reboot.
The tests will run each time you reset or cycle power
to the terminal until you disable Extended
Diagnostics. Setting a low repeat count will also
decrease the startup time.
AB PLCs
To Next Page
Loading...
Need help?
General
