What to do if my Allen + Roth WSWS-CS1C Indoor Furnishing closet tower can not hang on the wall?
If your Allen + Roth closet tower can't hang on the wall, it's likely due to incorrect mounting hole locations. Reinstall the wall hanging cleats, ensuring the space between them is 39-1/2 inches and the bottom two mounting holes are no less than 31-1/2 inches from the floor.
Why is my Allen + Roth WSWS-CS1C Indoor Furnishing pole kit tilting?
The Allen + Roth pole kit is likely tilting because the open and closed pole holders aren't installed at the same level. To fix this, use a quality level to ensure the pole holders are level with each other during installation.
How to fix a tilted Allen + Roth Indoor Furnishing closet tower?
If your Allen + Roth closet tower is tilted, the wall hanging cleats are probably not level. Reinstall them, making sure they are level to correct the issue.
What to do if screw went through the side panel of my Allen + Roth WSWS-CS1C Indoor Furnishing?
If a screw went through the side panel of your Allen + Roth Indoor Furnishing, it's likely because you used M4 x 38 mm wood screws to attach the pole holder to the side of the cabinet. Replace them with M4 x 14 mm wood screws instead.
Why one end of metal pole does not rest properly onto the open pole holder (YY) of my Allen + Roth WSWS-CS1C?
If one end of the metal pole doesn't rest properly on the open pole holder (YY) of your Allen + Roth Indoor Furnishing, the opening of the open pole holder likely doesn't face upward vertically. Ensure the flat edge of the open pole holder is level during installation using a quality level.
General| Product Name | Allen + Roth WSWS-CS1C |
|---|---|
| Category | Indoor Furnishing |
| Dimmable | Yes |
| Shade Material | Glass |
| Max Wattage | 60W |
| Voltage | 120V |
| Installation | Hardwired |
To Next Page