How to fix communication failure in ALLIANCE Heat Pump?
If you're experiencing a communication failure with your ALLIANCE Heat Pump, it indicates a communication breakdown between the remote wire controller and the main board. To resolve this, check the wire connections between the remote wire controller and the main board.
What to do if ALLIANCE ALLPH160R410 shows high pressure protect?
If your ALLIANCE Heat Pump is showing a high pressure protection error, it's likely because the exhaust pressure is too high, triggering the high pressure switch. You should check the high pressure switch and the cooling return circuit.
What causes low pressure protect in ALLIANCE Heat Pump?
If your ALLIANCE Heat Pump indicates low pressure protection, it means the suction pressure is low, activating the low pressure switch. To address this, check the low pressure switch and the cooling return circuit.
Why is there a high temperature difference between water inlet and outlet in my ALLIANCE Heat Pump?
A high temperature difference between the water inlet and outlet in your ALLIANCE Heat Pump suggests that the water flow volume is insufficient or the water system pressure difference is small. You should check the flow volume and inspect the water system for blockages.
How to troubleshoot flow switch failure in ALLIANCE ALLPH160R410?
If your ALLIANCE Heat Pump is experiencing a flow switch failure, it indicates there is no water or very little water in the water system. Check the flow volume and verify if the water pump is failing.
What to do if ALLIANCE ALLPH160R410 is antifreezing under cooling mode?
If your ALLIANCE Heat Pump is antifreezing while in cooling mode, it suggests that the water flow volume is not enough. Check the flow volume and see if the water system is blocked.
How to fix water inlet temp. sensor failure in ALLIANCE ALLPH160R410?
If the water inlet temperature sensor is failing on your ALLIANCE Heat Pump, it could be due to an open or short circuit. To resolve this, check or change the water inlet temperature sensor.
What causes water outlet temp. sensor failure in ALLIANCE ALLPH160R410?
If the water outlet temperature sensor is failing on your ALLIANCE Heat Pump, it might be open or short circuit. You should check or change the water outlet temperature sensor.
How do I address an ambient temp. sensor failure in my ALLIANCE Heat Pump?
If the ambient temperature sensor is failing in your ALLIANCE Heat Pump, it is likely due to an open or short circuit. In this case, check or replace the ambient temperature sensor.
What to do if pipe temp. sensor fails in ALLIANCE ALLPH160R410 Heat Pump?
If the pipe temperature sensor is failing on your ALLIANCE Heat Pump, it's likely because it's open or short circuit. You should check or change the pipe temperature sensor.
Schematic diagram showing the installation setup with other pool components.
Instructions for safe and proper electrical connection of the heat pump unit.
Step-by-step procedure for the initial power-up and operation of the heat pump.
Details how to start, shut down, and switch operating modes of the heat pump.
A table listing common malfunctions, their causes, and recommended solutions.
To Next Page
General