Page 9 of 9 User Manual
4.1 Using DGS
Follow the normal Allied DGS procedures, exactly as you would with a NXG or Aegis
controllers.
Sign on using Administrative credentials, navigate to the Utilities tab and click
“Download,” then supply the location for the RTA file and the INI file.
5 Configuration XML Files
5.1 INI files
NexgenIni.xml has been deprecated. NEXGEN.INI is fully supported, so that NEXGEN.INI files
may be used on the NXG, NXG-P, and Aegis platforms.
5.2 FpCfg.xml
Because NXG-P firmware supports any combination of manufacturers (Gilbarco, Wayne,
Bennett, Verifone, et cetera) for dispenser or in-pump card reader, the FpCfg.xml file is used to
specify information about each fueling point.
5.3 File download
Data files can be deployed to a NXG-P system via Allied DGS or some other utility using RFA.
This method uses an internal notification mechanism to inform the firmware that new data files
are available.
6 Installation & Programming
Please refer to the Installation Manual for all dispenser specific wiring, programming, and system
related inquiries. All Allied Controller Installation Manuals can be found by visiting the following
site: https://www.alliedelectronics.com/installation-startup-guides.html
To Previous Page
