Allied Healthcare VACUTRON CONTINUOUS-INTERMITTENT User Manual (English)

Questions and Answers:

C
Chelsea HawkinsAug 13, 2025
What to do if Allied Healthcare Medical Equipment unit fails to draw vacuum in all modes?
- D
  Daniel OneillAug 13, 2025
  If the Allied Healthcare Medical Equipment unit isn't drawing vacuum, several factors could be at play. First, aspirant may have been drawn into the unit, in which case you should flush the unit. It could also be due to no vacuum supply, so you should check the hospital vacuum level. Also, the setup might be loose or incorrect, so set up the unit. Clogged filters can cause this issue, so replace them. Finally, make sure the selector switch is fully engaged by moving the switch fully to the mode detent position.
A
Andrea MccoyAug 17, 2025
Why does Allied Healthcare VACUTRON CONTINUOUS-INTERMITTENT have erratic or low suction?
- A
  Andrew WelchAug 17, 2025
  Erratic or low suction in your Allied Healthcare Medical Equipment can stem from several causes. Begin by checking the hospital vacuum level, as a low vacuum supply could be the culprit. Another cause may be aspirant in the unit, so flush the unit. Also, a loose or faulty connection could be the reason, so set up the unit. A worn or obstructed regulator seat may also cause this, so clean or replace the regulator. Clogged filters can also lead to this issue, so replace the filters. Lastly, a stuck relief valve can be the reason, so replace the relief valve.
J
Jasmin HicksAug 20, 2025
What causes erratic vacuum gauge reading in Allied Healthcare VACUTRON CONTINUOUS-INTERMITTENT?
- B
  Barbara MartinezAug 20, 2025
  An erratic vacuum gauge reading on your Allied Healthcare Medical Equipment could be due to a few reasons. First, check the hospital vacuum level, as a low vacuum supply can cause this. Secondly, a worn or obstructed regulator seat may be the problem, so clean or replace the regulator. Finally, the gauge mechanism itself might be damaged, so replace the gauge.